|
|
Building Jigs
Used to make balancing your HLG or CLG much easier and more precise. You can add magnets (1/4" x 0.100") if you have a steel building surface. Laser cut from birch plywood.
|
Set of 2 wing rod support stands for 3.25mm OD rods, or #3 knitting needles. Laser cut from birch plywood. Can be used with one (only one hole in ribs, TE on building board), or two rods. Use with or without magnets (magnets sold separately).
|
Set of 2 wing rod support stands for 4.0mm OD rods, or #6 knitting needles. Laser cut from birch plywood. Can be used with one (only one hole in ribs, TE on building board), or two rods. Use with or without magnets (magnets sold separately).
|
Set of 2 wing rod support stands for 7.5mm OD rods. Laser cut from birch plywood. Can be used with one (only one hole in ribs, TE on building board), or two rods. Use with or without magnets (magnets sold separately).
|
Pair of wing support fixtures. Adjusts from 7/8" to 6 1/4" high, and angle tilts over the range of -6.5 to + 6.5 deg. Nylon bolts and wing nuts used to lock fixture after adjusting. For magnetic tables add 6 magnets to each fixture (not supplied).
|
Pair of biplane wing supports. Adjusts from 7/8" to 11" high, and angle tilts over the range of -6.5 to + 6.5 deg. Nylon bolts and wing nuts used to lock fixture after adjusting. For magnetic tables add 6 magnets to each fixture (not supplied)
|
Hardcopy of current catalogue with free shipping.
IF ORDERING >$60 OF MERCHANDISE AS A FREE CATALOG WILL BE INCLUDED.
| | |
|
|
|